REAR PANEL CONTROLS
USB: Record replay connector, (Dry on left channel, processed on right channel). USB2.0 is compatible with Windows XP
Windows 7 Windows 8 iPad
1-3 via camera USB adaptor, iPad 4 & iPad Mini
Dry signal send with level control +-12dB gain to optimise record levels.
Re-amp output jack allows Dry return signal from USB to be connected via jack cable to the Amp input.
FOOTSWITCH SOCKET: Connect the supplied FS4-IRT here using the supplied 5 pin DIN cable.This allows you to
remotely control the following functions: Channel, Clean, Reverb, and Boost. In order to operate the functions correctly,
set Pre-Boost and Clean to ON, and Channel to Lead.
LOUDSPEAKER CONNECTIONS: Connect your loudspeaker here. Ensure that the impedance switch is set correctly for
the cabinet(s) you are using. Mismatching your speaker impedance will reduce the performance of your amplifier, and in
extreme cases may damage the unit. The unit may be operated without a loudspeaker if desired, allowing you to record
silently, or use headphones to practice. When the loudspeaker socket is not used, an internal load is applied, protecting
the output transformer, and emulating the effect of loading it with a speaker. If no loudspeaker is to be used, ensure that
the speaker cable is removed from the amplifier.
® operating system, ® operating system & ® operating system. Also compatible with Mac ® &
® ® ® via Lightning-USB camera adaptor cable.
■
■
■
■
■
PHONES: Use this stereo socket to practice with headphones, or if you want to DI out.This socket features similar
emulation circuitry as the DI out. When using headphones, ensure Level is set to minimum and then increase to a
comfortable level. Using the Source switch, USB or the amplifier can be monitored.
AUX IN: A 3.5mm Stereo line input for connection of a CD or MP3 player as a backing track. Control the level of the input
using the volume control on your CD/MP3 player. This input is present at the DI and Headphone sockets, but not at the FX
send socket.
FX RETURN: Mono jack socket for the connection of the output of an external FX unit. This can also be used as a slave in
for the power amp. As the FX Loop is an insert type, this will mute the preamp signal.
FX LOOP SWITCH: Selects the FX Loop mode of operation:
-10dBu - For connection of FX units with a -10dBu nominal output level. As this is intended for devices with a lower
output level, this switch increases the gain of the FX Loop by 10dB.
0 dBu - For connection of FX units with a 0dBu nominal output level.
Bypass - Removes the FX Loop from the signal path.
FX SEND: Mono jack socket for connection to the input of an external FX unit.
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals