Laney IRT-STUDIO User Manual download pdf (Page 12)

REAR PANEL CONTROLS

MAINS INLET SOCKET - MAINS FUSE: Make sure the voltage indicated on the rear panel is correct for your country!

This drawer contains the main safety fuse for the unit. The fuse protects the amplifier from damage in the event of fault by

disconnecting the mains power supply.

HT FUSE: This fuse disconnects the high voltage DC power to the tubes within the amplifier in the event of a fault.

Replacing fuses - USE ONLY THE CORRECT SIZE AND RATING SPECIFIED ON THE PANEL. - Using a fuse that is too

large in current rating may cause serious, irreparable damage to the amplifier and presents a serious fire hazard. The fuse

ratings are detailed in the Specifications section of this manual, as well as printed on the rear of the amplifier. Fuses are

designed to protect, do not take chances.

DI: Use this socket to connect your amplifier to a PA system or recording interface. The socket features switchable speaker

emulation to shape the tone in a similar way to the loudspeaker, allowing a closer reproduction of the entire Guitar - Amp -

Speaker system. The socket has a fully balanced output, (switchable +4dB/-30dB & Ground Lift) for maximum noise

reduction. You may use this socket to record without a loudspeaker connected for silent recording as there is a protective

load applied when the speaker socket (9) is not used.

Spare fuse located

in the fuse drawer.

L ZB 1 2 3 4

TIP

(Use +4dB to connect to powered monitor cabinets. Use -30dB to avoid noise and overload for mixing desks

inputs)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Laney IRT-STUDIO User Manual Page 12